Pre-installation Guidelines

Sun Screen film is comparatively easy to install because the holes help prevent air bubbles from forming and the film conforms well to curved glass surfaces. Installation is simple if you use the right tools and follow a few basic rules.

Prior to installation of actual printed graphics, however, we recommend attaching a small amount of Sun Screen film to glass as a test to help you become accustomed to the film's characteristics, including adhesion strength.

Glass surface must be clean. Use soap and water only, no solvents. Glass surface must be completely dry. Use lint-free cloth or brown industrial paper towels to dry the glass.

Temperature of glass must be moderate. In extremely cold weather (below 40° F/ 5°C), apply film in late afternoon, after windows have warmed up. Applying film to glass that is too cold may adversely affect the adhesion of the film.
Film that has been stored in extremely cold conditions can become brittle. Allow the film to warm up before installing to prevent it from cracking. In extremely warm weather (above 90° F/ 32° C), apply film in early morning, when glass surface is still cool. Applying film to glass that is too hot can cause the film to stretch. Basic Installation Instructions

Note Before Installing: unpack material and lay flat or hang for 24 hours to stabilize

1. Lift the upper edge of the liner away from the vinyl and fold back approximately 3-6 inches (depending on the size of the graphic).

2. Carefully position the film so that it is properly aligned on all sides, then press the upper corners in place using light pressure.

3. Using your hand or a soft plastic squeegee, lightly press the film in place.

4. Working from the top of the graphic to the bottom, continue by peeling away more of the liner and applying light pressure to the film. Continue in this manner until the liner is completely removed and the window graphic is in place.

5. Using a utility knife, carefully trim away any unneeded portion of the graphics.

6. If you are installing more than one panel, properly align the next graphic in relation to the adjoining panel(s).

Note: In the case of graphics that must be seamed together, install the two pieces so that the edges of the film butt against each other, with the holes aligned (don't overlap the two edges of the film).

7. Follow steps 1 through 5 above.

8. Finally, squeegee the film from the center and work outward in all directions.

9. Be sure to squeegee the edges firmly in place.

10. Step back and admire your work!